Always turn off and unplug your indoor satellite receiver from the wall outlet before connecting or disconnecting the RV3. Making coaxial connections while the receiver is actively sending power can short-circuit the LNB or the meter. Step 3.2: Wiring the Meter
The Deutsche Technologies RV3 is a handheld, DVB-S compliant, 3.5-inch color LCD meter designed for fast satellite dish alignment. It features signal strength, quality, and bit error rate measurements, along with a 1950mAh battery, DiSEqC 1.0 support, and AV functionality. For more details, visit access2qld.com.au Access 2 QLD Antennas & Satellites Deutsche Technologies RV3 Digital Satellite Finder
You might be locked onto the wrong satellite. Check your dish elevation and try again.
Once powered on and connected, follow these steps to find your satellite: Press the MENU key.
Slowly sweep the dish from left to right (Azimuth). Move it in small 1-degree increments, pausing for 2 seconds at each step to allow the digital processor to register the signal. Step 3.5: Lock and Fine-Tuning
during fine-tuning, press the button again to scale down the reading, then continue adjusting until you find the true peak. Tighten all bracket bolts on the dish firmly, ensuring the dish does not shift while tightening. Turn off the receiver, disconnect the RV3 meter, and reconnect the main cable line directly from the LNB to the house receiver. 5. Understanding the Display Indicators Strength Bar (
Headline: Stop Guessing, Start Watching! Master Your RV Satellite Setup
This F-type coaxial port connects directly to the feedhorn/LNB located on the arm of your satellite dish.
Connects to the Low-Noise Block downconverter on your satellite dish.
: Instructions on using the built-in LCD screen to view actual channel pictures and live signal strength/quality bars. Data Metrics : The manual explains how to read technical data such as (Signal-to-Noise ratio), Key Device Specifications According to technical documentation, the RV3 includes:
Ensure the receiver is plugged into AC power and switched on. Check that the LNB power setting in your receiver’s menu is set to "ON". Verify that the cables are plugged into the correct ports ("To REC" and "To LNB").
Displays a 0-99% graphical scale for signal metrics.
