Novastar H Series Api Jun 2026

The H Series supports multiple communication layers depending on your integration needs: HTTP OpenAPI : Uses standard requests with

Poll the processor to verify if an input source has an active, stable sync signal before switching it live. 2. Screen and Layer Configuration

Direct control over the LED driver’s brightness without touching the source signal. novastar h series api

Used for advanced integration, web UI components, and modern control platforms. The processor acts as a web server, accepting GET , POST , PUT , and DELETE requests with JSON payloads. Primary API Capabilities and Control Scopes

set:brightness

Automate day/night brightness curves and inject custom EDIDs into input ports. 🛠️ Network Configuration & Connection

import socket # Configuration variables H_SERIES_IP = "1192.168.1.100" # Replace with your H-Series IP API_PORT = 6000 # Replace with your specific firmware API port COMMAND = "GET_DEVICE_STATUS\r\n" # Conceptual placeholder for status string try: # Establish connection client = socket.socket(socket.AF_INET, socket.SOCK_STREAM) client.settimeout(3.0) client.connect((H_SERIES_IP, API_PORT)) # Send command client.sendall(COMMAND.encode('utf-8')) # Receive response response = client.recv(1024) print("Response from H-Series:", response.decode('utf-8')) except socket.timeout: print("Connection timed out. Check IP and network paths.") except Exception as e: print(f"An error occurred: e") finally: client.close() Use code with caution. Best Practices for Developers and Integrators Used for advanced integration, web UI components, and

: The most common method. Send JSON-formatted commands to the device's IP address on UDP Port 6000 Serial (RS232) : Connect via the physical COM port. Default settings are 9600 Baud Rate , 8 Data Bits, 1 Stop Bit, and no parity. EZ LED Visual 2. API Authentication & Security For newer firmware, NovaStar uses an framework that may require encryption: OpenAPI Management : Enable this in the device Web GUI under Settings > Open API Management to create a "Project" and obtain a Secret Key Request Format : Messages consist of a . If encryption is enabled, you must use an MD5-based signature

"code": 0, "message": "Success"

Through API calls, an external system can load new calibration coefficients or update the “brightness and chroma” correction data. This is vital for rental and staging applications where LED tiles are reconfigured daily; a barcode scan of a tile can trigger an API command to apply its specific correction file.