High Quality | V2000-c Rfid Access Control User Manual
The controller indexes users by allocating specific memory slots. Recording user slot assignments in an offline spreadsheet is highly recommended for tracking physical cards. Adding User Access
Verify your relay wiring. If you are using a magnetic lock (Fail-Safe), ensure it is wired to NC and COM . If using an electric strike (Fail-Secure), ensure it is wired to NO and COM . Also, check if the relay opening time is accidentally set to 0 seconds. Issue: Lost Master Programming Code.
| Step | Action | | :--- | :--- | | 1 | Press * + Master Code + # | | 2 | Press 1 (Add User) → # | | 3 | Swipe card (beep 1x) | | 4 | Enter 4–6 digit PIN → # | | 5 | Swipe same card again to confirm → # | V2000-c Rfid Access Control User Manual
Never leave the default system password active. To change it: Enter Programming Mode. Press 0 . Enter your , then press # .
| Parameter | Value | | :--- | :--- | | | V2000-c | | Operating Voltage | 10V – 14V DC (12V nominal) | | Standby Current | ≤ 80mA | | Maximum Current | ≤ 150mA (excluding lock) | | Relay Contact Rating | 3A @ 30V DC (resistive) | | RFID Frequency | 125kHz (EM4100) or 13.56MHz (Mifare S50/70) | | Read Range | 2-5 cm depending on card type | | User Capacity | 500 (cards + PINs) | | Event Log | None (standalone) | | Operating Temperature | -20°C to +60°C (-4°F to 140°F) | | Humidity | 10% – 90% (non-condensing) | | Dimensions (mm) | 120 x 78 x 25 | The controller indexes users by allocating specific memory
is a standalone RFID access control system designed for single-door security. It supports up to 1,000 users
The V2000-c does not support over-the-air or user-applied firmware updates. The firmware is factory-burned. If you experience glitches (random beeping, LED freezing), perform a factory reset. If persists, replace the mainboard – these units are cost-effective to replace. If you are using a magnetic lock (Fail-Safe),
Comprehensive User Manual & Guide for the V2000-c RFID Access Control Keypad The V2000-c RFID Access Control Keypad
Locate the button or jumper pins on the main circuit board inside the housing.
In the world of modern security, installing a device is only half the battle. The other half is knowing how to configure it to suit your specific needs. The is a popular choice for small businesses, offices, and residential complexes due to its reliability and standalone design. However, to unlock its full potential, a deep dive into the User Manual is essential.
